Logo

B0007 Engine Code Repair

Meaning of B0007 engine trouble code is a kind of body trouble code and when the check engine light comes B0007 code on the first you should check is the gas cap. Pull over, retighten it, and take a look at the cap to see if it has any cracks in it. Continue driving and see if the check engine light turns off. Alternately, you can purchase a gas cap for about $3 at an auto parts store. All you need to do is take the old one off and screw on the new one. If you've already made it to the store, you might as well just replace it. While not car-threatening, it's good to take care of this right away to improve gas mileage.

B0007 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for B0007 code is occuring now you should check B0007 repair processes.
Now don't ask yourself; What should you do with B0007 code ?
The solution is here :

B0007 Possible Solution:

B0007 Engine

Power Steering Pressure (PSP) Switch Signal Malfunction The PCM counts the number of times vehicle speed transitions from 0 to a calibratable speed. After a calibratable number of speed transitions the PCM expects that the PSP input should have changed. This DTC is set if the transition is not detected. Vehicle towed with engine running Power steering hydraulic concern was repaired but DTC was not erased PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged Check, if possible, if vehicle was towed or power steering service was performed. Observe PSP V PID while checking wires for intermittents.

B0007 Code Meaning :

B
OBD-II Diagnostic Body (B) Trouble Code For Engine

0
Intake Valve Control Solenoid Circuit Low

0
Injector Circuit Malfunction - Cylinders

0
Crankshaft Position Sensor A Circuit Malfunction

7
Ignition Coil A Primary/Secondary Circuit Malfunction

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

B0007 OBD-II Diagnostic Body (B) Trouble Code Description

B0007 engine trouble code is about Ignition Coil A Primary/Secondary Circuit Malfunction.

Main reason For B0007 Code

The reason of B0007 OBD-II Engine Trouble Code is Injector Circuit Malfunction - Cylinders.

B0007 the main thing to check is to verify the operation of the VCT solenoid. You're looking for a sticking or stuck VCt solenoid valve caused by contamination. Refer to vehicle specific repair manual to perform component tests for the VCT unit.